Die issues

Post Reply
0ebuny
TNN nerd
Posts: 2712
Joined: Mon Aug 08, 2005 9:38 am
Location: Hamilton

Die issues

Post by 0ebuny » Sat May 21, 2011 6:04 pm

well i have two snap presses one i got ages ago and one thats i got about 6 months after the first one, they both get used about the same amount, (got dies sets at the same time as presses)

one stud die barely holds the stud it falls out constantly and is generally really hard to use ive got a feeling it was slightly better at the start but by the time i got the second one it fell out often. ive had them both a few years since then and the first one is still hard to use and the second one still works fine so did the first one wear out really quickly (less than 6 months?) or was it faulty to start with? i have absolutely no problems with the second one i got which ive been using for years now.

any ideas?
BEX

wahm to Mikayla waterbirth on 7/3/05, tristan 4/2/07 and Akasha (unplanned homebirth) 25/4/11
one angel baby Zane



Bum Basics: cheak out our facebook page were having a big sale.

ditto
TNN guru
Posts: 5255
Joined: Mon May 01, 2006 10:26 am
Location: Wellington

Re: Die issues

Post by ditto » Sat May 21, 2011 6:47 pm

I had one like that - it was a nuisance. I put a little bit of blu-tack inside it but it really only helps temporarily. I have a new die now that's much better.
Mama to Braden (5/05), Rosalia (6/08), Corin (3/10) and Annelise (2/14)

Post Reply

Return to “Snaps and presses”

Who is online

Users browsing this forum: No registered users and 2 guests